Development of an immunochromatographic test strip for the detection of ochratoxin A in red wine

ABSTRACT Humans and animals are exposed to mycotoxins naturally present in foods. Ochratoxin A (OTA), one of the most abundant and toxic mycotoxins, is ubiquitous in nature and harmful to humans and animals. In this study, we developed a rapid, simple, specific, and sensitive lateral-flow immunochromatographic assay for detection of OTA in 0.01 M phosphate-buffered saline solution (PBS) (pH 7.4) and in red wine. We produced sensitive and selective monoclonal antibody against OTA. Under optimized conditions, the cut-off limit of the test strip was 10 ng/mL OTA in 0.01 M PBS (pH 7.4) and in red wine. The results were obtained within 10 min. Therefore, our developed method is useful for the detection of OTA in red wine.

The mycotoxin ochratoxin A (Figure 1, OTA) is a ubiquitous chlorophenolic mycotoxin that is produced by fungi of the genera Penicillium and Aspergillus. Due to their toxicity and prevalence, mycotoxins constitute a major concern in food safety (Kokkonen, Jestoi, & Rizzo, 2005). The occurrence of OTA in food and feed has been reported worldwide. Wine and cereal are considered to be one of the major food commodities susceptible to OTA contamination (Karczmarczyk et al., 2016;Karczmarczyk, Haupt, & Feller, 2017). Even though it is difficult to completely eliminate mycotoxins from foods, it is possible to decrease the risk of exposure via a rigorous monitoring programme. In Brazil and in the European Union, the maximum permissible level of OTA in wine is 2 µg/kg (Andrade & Lancas, 2017;Zhu et al., 2015).
Immunoassays based on antibody-antigen recognition are highly specific and could be a sensitive tool for the detection of OTA. The enzyme-linked immunosorbent assay (ELISA) (Garcia-Fonseca, Ballesteros-Gomez, & Rubio, 2016;Kim, Lee, Nam, Seo, & Yoo, 2017) has high specificity, is applicable for high throughput applications, requires simple sample preparation steps, and is cost-effective (Kong et al., 2017;Peng, Liu, Kuang, Cui, & Xu, 2017). The lateral-flow immunochromatographic strip allows the semi-quantitative analysis of several drug residues and has become increasingly popular because it is simple, rapid (can be performed in 5-10 min), specific, and sensitive.
OTA residues in cereal samples (Sun et al., 2016), agricultural products (Li et al., 2013;Majdinasab et al., 2015), and Astragalus membranaceus (Zhou et al., 2016) have been detected using the lateral-flow immunochromatographic strip test. However, no studies have used the immunochromatographic lateral-flow test to determine OTA in red wine samples. The aim of this study was to develop a lateral-flow immunochromatographic test strip for the detection of OTA in red wine.

Preparation and characterization of monoclonal anti-OTA antibody
OTA was conjugated to BSA using the CDI method (Cao et al., 2015). Briefly, OTA was mixed with BSA at a 50:1 ratio and dissolved in 2 mL of acetone with CDI. The mixture was stirred at room temperature for 3 h to form an activated amide intermediate. The reaction mixture was subsequently vacuum-dried and the resulting yellow powder was dissolved in 2 mL of anhydrous N-N-dimethylformamide (DMF). This solution was added dropwise to BSA dissolved in 4 mL of carbonate buffer (0.05 M, pH 9.5).
After stirring for 5 h at room temperature, OTA-CDI-BSA ( Figure 2) was dialysed against 0.025 M carbon buffer for 3 days at room temperature, and stored at -20°C until use.
We used female BALB/c mice (6-8 weeks age) to produce mAbs against OTA. OTA was conjugated to KLH using the ester method . The mice were immunized subcutaneously with OTA-EDC-KLH ( Figure 3). Briefly, a mixture of OTA, carboxyl-reactive carbodiimide cross linker (1-ethyl-3-[3-dimethylaminopropyl]carbodiimide hydrochloride) (EDC), and N-hydroxysuccinimide (NHS) were added to DMF and incubated for 24 h (solution 1). KLH was mixed with 0.01 M phosphate-buffered saline solution (PBS) (solution 2). Solution 1 was slowly added to solution 2 while stirring, and the mixture was stirred continuously for 8 h at room temperature. OTA-EDC-KLH was dialysed against distilled water for 3 days and subsequently against 0.01 M PBS for 3 days.
We used FCA in the first immunization and FIA was used in the subsequent booster injections. The mice were immunized with OTA-EDC-KLH every 3 weeks with 100 µg (first immunization) and 50 µg (subsequent injections; 2-5 times). We analysed the antibodies in blood samples of mice using ELISA. The mouse with the highest titre was sacrificed and its splenocytes were fused with Sp 2/0 murine myeloma cells. The resulting hybridomas were screened using indirect ELISA. The selected hybridoma cells were expanded and injected into BALB/c mice to produce mAbs. The ascites were harvested and purified by the caprylic acid-ammonium sulphate precipitation method , and the purified mAbs were stored at -20°C.

Development of the immunochromatographic strip
Preparation of colloidal GNPs All the solvents were prepared with ultrapure water and passed through a 0.22 µm filter membrane. Chlorauric acid (0.1 g/L, 25 mL) was heated to boiling under constant stirring. Following the addition of 1.0 mL of 1% w/v sodium citrate tribasic dehydrate, the mixture was stirred for 30 min. When the colour of the solution turned wine-red, it was allowed to cool to room temperature, and stored at 4°C. Observations by transmission electron microscopy revealed that the GNPs had a nearly uniform particle size of 15 nm.

Test procedure and principle
Prior to the test, 50 µL of gold-labelled mAbs is mixed with 150 µL of sample solution, allowed to react for about 5 min, and added onto the sample pad. The solution migrates to the absorbent pad, and the test results are visualized within 5 min. In OTA-positive samples, OTA competes with OTA-BSA conjugates embedded in the test (T) line for the finite amount of anti-OTA mAb. When a sufficient amount of OTA is present, free OTA binds to gold-labelled mAb, preventing mAb from binding to OTA-BSA in the T line. Therefore, the higher the OTA content in the sample, the weaker the colour of the T line. In OTA-negative samples, the limited amount of colloidal goldlabelled mAb is trapped by the immobilized OTA-BSA conjugate, and a clearly visible red T line appears.
The sample must reach the control (C) line, which contains goat anti-mouse IgG antibody. Therefore, the C line must always appear in a successful test, whereas the T line will only appear when the sample is negative (Figure 4(A)). The appearance of the C line alone is indicative that OTA is present (Figure 4(B)), whereas if neither the C line nor the T line appears (Figure 4(C)), the test procedure is incorrect or the strip is invalid, indicating that the test should be repeated with a new strip.

Sensitivity of the test strip
The sensitivity of the test strip was determined by testing OTA-containing samples. The OTA standard was diluted to 0, 0.5, 1, 2.5, 5, and 10 ng/mL in 0.01 M PBS (pH 7.4), and the detection limit was determined. The sample solution (100 µL) was mixed with 50 µL gold-labelled mAb, allowed to react for 5 min, and added onto the sample pad. After 5 min, the test strip reader was used to measure the colour intensities. The lowest detection limit (LDL) that could be detected by the naked eye was defined as the amount of OTA that produced a colour reaction on the strip that was visibly different in intensity from that obtained from 0 ng/mL OTA. Six replicates for each concentration were analysed on the same day.

Detection of OTA in red wine
We obtained red wine from a local market. Red wine (10 mL) was mixed with 0.2% PVP, Vortexed for 3 min, and centrifuge at 4000 rpm for 6 min. Two layers were formed; the pH of the resulting supernatant was adjusted to 7, and the samples were spiked with OTA solution (10 µg/mL, prepared with 0.01 M PBS, pH 7.4). The OTA concentrations in red wine were 0 (control), 0.5, 1, 2.5, 5, and 10 ng/mL. Six replicates for each concentration were analysed using the test strips.

Optimization of the strip test
The strip materials must be hydrophilic and have consistent flow characteristics in the immunochromatographic assay. NC must be hydrophobic; however, it can be rendered hydrophilic with the addition of surfactants. It is important to choose the appropriate surfactant when developing these assays because not every protein is compatible with every surfactant. In this study, suspension buffer (0.02 M PBS, 5% sucrose, 2% sorbitol, 1% mannitol, 0.1% PEG, 0.1% tween, and 0.04% NaN 3 ) was mixed with 13 reagents including PVP, PEG, polyvinyl alcohol (PVA), BSA, casein, sucrose, trehalose, sorbitol, mannitol, tween-20, brij-35, triton X-100, and Rhodasurf® On-870 (an ethoxylated oleyl alcohol). Figure 5 shows that the surfactants containing PEG, casein, sucrose, trehalose, sorbitol, and mannitol resulted in adequate and stable colour reactions. Figure 6 shows that casein resulted in the best signal colour on the T line. The concentration of mAbs in GNPs and of the coating antigen affects the sensitivity of the assay. Two different concentrations of mAbs (4 or 8 µg/L) were allowed to react with OTA-negative samples (0 ng/mL) and OTA-positive samples (25 ng/mL). Figure 7 shows that there were significant differences in colour intensity between 4 and 8 µg/L. We observed that the optimum concentration of mAb in GNP was 8 µg/L based on the colour intensities on both lines (OTA-positive and OTA-negative samples). Additionally, there were significant differences in colour intensity at 1 and 2 mg/mL coating antigen. At 1 mg/mL coating antigen, the colour intensity of the T line was weaker than at 2 mg/mL, suggesting that more sensitive detection could be achieved at 2 mg/mL coating antigen. Therefore, the optimum conditions of our developed assay consisted of 2 mg/mL coating antigen and 8 µg/L mAb in GNP.
We investigated the sensitivity of the assay using a series of OTA standards diluted in 0.01 M PBS (pH 7.4). The LDL was defined as the amount of OTA that produced a colour  reaction on the strip that was visibly different in intensity from the obtained from OTA-negative samples. Figure 8 shows that the signal colour on the T lines changed from strong (0 ng/mL) to weak and completely disappeared at 10 ng/mL OTA.
In this study, we determined matrix effects using red wine. One of the major advantages of the immunochromatographic strip assay is its rapidity and ease of use. The samples was spiked with OTA standard solution (10 µg/mL, prepared with 0.01 M PBS pH 7.4) at final OTA concentrations of 0.5, 1, 2.5, 5, and 10 ng/mL. Six replicates were determined at each concentration. The spiked samples were analysed using our developed method. Figure 9 shows that colour intensity decreased with increasing OTA concentrations. The signal colour on the T line changed from strong to weak with increasing OTA concentrations and completely disappeared at 10 ng/mL.

Conclusions
A sensitive colloidal lateral-flow immunochromatographic assay was developed for the rapid detection of OTA in red wine samples. Under optimized conditions, the assay had a cut-off value of 10 ng/mL OTA in 0.01 M PBS (pH 7.4) and red wine. The results were obtained in 10 min. The lateral-flow immunochromatographic assay represents a sensitive and rapid detection method of OTA in red wine.